Skip to main content

5.3.6. Welding start condition– Exclusive setting for EWM

5.3.6. Welding start condition– Exclusive setting for EWM​

 

(1)  JOB mode: <Job mode off, Job mode active>

Set the welding mode that is supported by the EWM AlphaQ welders. The details for individual modes are as below.

-    Job mode off: Welding will be performed after reflecting the feeding speed and the voltage offset in the welder according to the synergic data.

-    Job mode active: Welding will be performed by using the job data saved in the welder.

 

(2)   Welding mode

Set either to use or not use pulse welding.

 

(3)   Super pulse function

Set either to use or not use the super pulse (2 stage pulse) function for the pulse welding.

 

(4)   Job Nr. (synergic)

Enter one of the synergic numbers and job numbers as needed. Pressing the [Help] key will make display a dialog box in which a job number can be set properly for the welding method, material, gas, and diameter of wire.

 

(5)   Dynamic correction: [  0] (Range: -40.0 ~ 40.0)

Set the dynamic correction value. If the value is small, a strong and stable arc will be generated and the amount of spatter will increase. When the value is large, a smooth arc will be generated and the amount of spatter will decrease

 

(6)   Lift arc start: <Use, No use>

Sets whether to use the lift arc function when starting the welding. The use of the lift arc function can reduce the occurrence of large spatters at the start of the welding.