1.3.3. Changing current/voltage change welding
1.3.3. Changing current/voltage change welding
While carrying out teaching for the arc welding operation, this function can be used to change the current/voltage in the middle of welding to find a proper level of current/voltage.
This function allows the change in current/voltage in real time while in welding operation to find the optimal condition, and also allows the saving of confirmed conditions as the actual welding conditions.
The details of the function and the setting method are as below.
(1) Entering the change arc welding current/voltage dialog box
① Carry out the arc welding in auto mode.
② Indicate the user key at the bottom by using the [User Key] key
③ Enter the [F7: change I, V in arc welding] key in case of arc welding shortcut key
④ Entering the dialog box is complete
(2) Current and voltage adjustment unit during welding, and the adjustment key
① Cursors Up/Down: Welding current goes up/down by 1[A]
② [SHIFT] + Cursor Up/Down: Welding current goes up/down by 5[A]
③ Right/Left Cursors: Welding voltage goes up/down by 0.1[A]
④ [SHIFT] + Cursor Right/Left: Welding voltage goes up/down by 0.5[A]
(3) Welding speed and weaving parameter adjustment key
① Speed HI/LOW: Increases/decreases the welding speed by0.1[cm/min]
② [SHIFT] + Speed HI/LOW: Increases/decreases the welding speed by 0.5[A] [cm/min]
③ F1/F2: Increases/decreases the weaving width(left) by 0.1[mm]
④ [SHIFT] + F1/F2: Increases/decreases the weaving width (left) by 0.5[mm]
⑤ F3/F4: Increases/decreases the weaving width (right) by 0.1[mm]
⑥ [SHIFT] + F3/F4: Increases/decreases the weaving width (right) 0.5[mm]
⑦ F5/F6: Increases/decreases the weaving frequency by 0.1[Hz]
⑧ [SHIFT] + F5/F6: Increases/decreases the weaving frequency by 0.5[Hz]
(4) Current/voltage change auto saving setting
① Entering『[F2: System]』 → 『4: Application parameter』 → 『2: Arc welding』
② 14: Arc welding current/voltage change auto saving setting as Enable, Disable
③ Disable: Users save by using the [F7: Record] key. The changed content will be deleted when entering by using the [ESC] key.
④ Enable: The changed content will be saved in the welding condition immediately when the user changes the value.