Skip to main content

5.1.14. Inlet of the Gas Spring Bearing

5.1.14. Inlet of the Gas Spring Bearing​

 

 

Figure 5.8 Inlet of the Gas Spring

 

 

 

(1)   Open the nipple cap 1/8, and inject grease through the grease nipple A-PT1/8 using a grease gun (Air pressure 5–7 kg/cm2, decompression not required.)

 

ü  Grease type: GADUS S3 V220C 2

ü  Initial grease injection amount: 15cc (13.5g)

ü  Grease reinjection amount: 7cc (6.3g)

 

(2)   Fill the grease through the grease nipple and inject it until the new grease comes out in 360° around the bearing through the gap between the NILOS-Ring and the bearing.

 

(3)   Wipe the grease discharged to the outside because of excessive injection of grease with a cloth.

 

(4)   Wipe the inlet with a cloth and assemble the nipple cap back into place.