7.2. Warning messages

7.2. Warning messages

 

Code	W0109	Brake slip (Set value exceeded)
Details	Brake slip measured at the time of stud welding exceeded the brake slip detection range set in the welding sequence.
Measure	Check set brake slip detection range, and change the setting to a higher value if required.

 

Code	W0105	Total tip exceeds consumption for exchange.
Details	This occurs when total moving tip consumption detected by the gun search exceeds the tip exchange consumption (moving + fixed) set in the welding gun parameter.
Measure	Check the set maximum tip consumption. Confirm that the reference location for Gun Search has been registered normally. Replace the tip.

 

Code	W0106	Moving tip exceeds consumption for exchange
Details	This occurs when total moving tip consumption detected by gun search exceeds the tip exchange consumption (moving) set in the welding gun parameter.
Measure	Check set tip exchange consumption (moving). Confirm that the reference location for Gun Search has been registered normally. Replace the tip.

 

Code	W0107	Fixed tip exceeds consumption for exchange
Details	This occurs when total fixed tip consumption detected by gun search exceeds the tip exchange consumption (fixed) set in the welding gun parameter.
Measure	Check set tip exchange consumption (fixed). Confirm that the reference location for gun search has been registered normally. Replace the tip.

 

Code	W0108	Actual squeeze force during jog operation exceeded the set value
Details	This occurs when actual squeeze force value exceeds the set value during manual axis squeezing. Operate the servo-gun axis to the opposite direction.
Measure	Confirm that the squeeze force value of the axis you intend to operate has been sufficiently set. Contact the servo-gun manufacturer, as a mechanical problem with the servo-gun is likely.

 

Code	W0109	Unselected servo gun cannot be operated manually
Details	The servo gun you intend to operate is different from the selected servo gun number.
Measure	Servo gun should be operated by manual jog after being selected. Select the servo gun you intend to operate with the R210 code before operating.