4. Error and Warning

 

Code	E6310	Axis sealer pressurization error too high
Description	Tolerances of pressure sensor measurement and motor measurement pressure exceeds allowed ranges.
Action	1) Check the sealer pressurization tuning. 2) Check the pressure sensor operation.
Code	E6311	Sealer pressurization too high for filling
Description	Measured pressure exceeds maximum pressure.
Action	1) Check if the pump pressure is set too high. 2) Check the pressure sensor operation.
Code	E6312	Sealer pressurization too high for waiting for axis
Description	Sealer pressure exceeds the allowed range.
Action	Check the sealing equipment.
Code	E6313	Sealer pressurization too low
Description	Sealer pressurization is lower than the allowed range.
Action	Check for sealer leakage and pressure sensor operation.
Code	E6314	Axis sealer pressurization exceeded maximum value.
Description	Sealer pressurization exceeds the allowed maximum range.
Action	1) Check if the discharge amount is too high. 2) Check if the viscosity of the sealer solution has increased because of low temperature. 3) Check the discharge valve for opening/closing and the sealing equipment.
Code	E6315	Axis sealer pressure control time out
Description	Exceeded time to reach target pressurization for sealer.
Action	1) Check the specified value and pressure tuning. 2) Check the valve for opening/closing and any leakage.
Code	E6317	Sealer filling complete time out
Description	Filling complete condition was not met within the time limit.
Action	1) Check the input valve operation and supply pump pressure. 2) Check the operation of the filling-complete signal or pressure sensor.
Code	E6318	Sealer pressure sensor data error
Description	Pressure sensor data failed.
Action	Check for sensor connection.

 

 

 

Code	E6319	Sealing equipment communication error
Description	There is an error for communication with the sealing equipment.
Action	Check for connection with the equipment.
Code	E6320	Sealer valve control signal output unavailable
Description	The valve control signal cannot be outputted.
Action	Stop internal PLC or set SP11 to “On” to run it.
Code	E8020	Jog is not available for the sealer axis.
Description	The jog function is not available because parameter settings are not complete.
Action	Set sealing parameters.
Code	E12120	Sealer commands cannot be executed.
Description	Sealing condition settings are not complete.
Action	Set sealing conditions.
Code	E12121	Sealer gun number setting error
Description	The sealing gun number setting is not valid.
Action	Check the gun number setting and gun allocation signal setting.
Code	E18106	Sealer discharge amount setting is not appropriate.
Description	The sealer discharge amount setting value is not specified.
Action	Set the sealer discharge amount for additional axis settings.