Skip to main content

5.1.8. Gas Spring Bearing

5.1.8. Gas Spring Bearing​

 

 

Figure 5.8 Gas Spring Grease Inlet/Outlet (Opening of cover)

 

 

n Grease Injection Method

 

(1)   Open the nipple PT1/8 in the back of outlet and grease it through the nipple PT1/8 in the back of inlet. (Air pressure 5~7kg/cm2, Decompression is not needed.)

 

ü  Grease type: GADUS S3 V220C 2

ü  Initial amount of grease injection : 15cc (13.5g)

ü  Amount of grease refueling : 7cc (6.3g)

 

(2)   Inject grease through the grease nipple until the new grease is squeezed out from the gap between the Nilos ring and the bearing in 360° direction of the bearing.

 

(3)   Clean up discharged grease caused by excessive fueling with a cloth.

 

(4)   Clean the inlet and outlet using a cloth and reassemble the nipple on the side of outlet.